Preparing for simulation
Arm
Setting up an Intravenous (IV)
IV cannulation can be performed.
 |
NOTE
Only use purified water (distilled) to simulate IV drugs. This prevents clogging of the system.
Connecting a drain bag
The IV fluid system is an open system. IV fluids are drained as they are administered.
 |
Connect an IV overflow tube and reservoir bag to the IV fluid drain port under the Patient Simulator’s arm.
Excess fluid will drain into the reservoir bag during the simulation.
NOTE
The smaller drain port is for the IV drain bag and the larger drain port is for the IO drain bag.
Preparing an IV with a silicone dressing base
For better adhesion of the IV dressings, position the silicone dressing base onto the arm skin.
Place the dressing.
Insert the IV cannula.
Connect the tubes (luer lock) to the cannula and drain bag.
Secure the IV area with tape.
NOTES
The silicone dressing base can be used multiple times, and does not need to be replaced after each use.
An IV drip can be set up to administer fluids into the cannula.
Automatic NIBP monitoring
SimMan CC enables bilateral, automatic NIBP monitoring with a clinical monitor.
Locate correct connector (supplied) to connect BP cuff to Patient Monitor.
Attach connector to BP cuff (use a Y-connector if the patient monitor uses a dual tube).
Connect short tube with angled connector to BP port and longer tube to the Patient Monitor.
The NIBP system delivers simulated blood pressures with an accuracy of ≤ 10 mmHg (at 15-25 °C, 15-85% RH).
NIBP system range | |
|---|---|
Diastolic blood pressure | 40-130 mmHg |
Systolic blood pressure | 60-200 mmHg |
NOTE
Only use the Blood Pressure cuff supplied with SimMan CC
Refer to LLEAP Help Files for complete blood pressure measurements and operating information.
SpO2 monitoring
The SimMan CC SpO2 finger contains a light diode and light sensor. When the beam between the diode and sensor is broken, the Patient Monitor Application registers that the SpO2 probe is connected.
Ensure that the index finger skin is correctly aligned with the (translucent) window area.
Clip the probe on to the finger ensuring that it is firmly positioned over the SpO2 window area.
If positioned incorrectly a reading may not be recorded on the monitor.
SpO2 System | |
|---|---|
SpO2 values range (minimum) | 70-100% SpO2 |
SpO2 values accuracy of ≤ 5% | 70-89% SpO2 |
SpO2 values accuracy of ≤ 2% | 90-100% SpO2 |
Intraosseous (IO) injection
IO simulation with needle insertion is possible through the humeral bone.
Recommended Device Sizes | |
|---|---|
BIG Automatic Intraosseous Device | 15 G |
EZ-IO, 15 G x 1” | 1.8 x 25 or 45 mm |
CAUTIONS
Incorrect use of larger devices can damage the IO bone and/or internal components. The smaller size is recommended.
Do not inject fluids into the pads unless approved IO modules with fluid outlets are in place.
NOTES
Ensure that the IO bone has not already been pierced or used.
To repair and replace the IO bone refer to Replacing the arm IO bone.